Firefly and PC GAMESS-related discussion club

 
Learn how to ask questions correctly  
 
 

 

Thomas Pijper
thomaspijper@hotmail.com

I've try it myself and observed the same behavior. A RHF geometry optimization with $STATPT NPRT=0 causes orbitals to be printed at the final geometry. Final orbitals are also printed for the same job at the SS-MCSCF level. However, at the SA-MCSCF level final orbitals are not printed.

I do not know why this is the case. If I were to hazard a guess, I'd say that the final orbitals of the current geometry are no longer present in the system memory at the end of the gradient calculation (as calculation of the gradient requires two additional SCF procedures) and thus aren't available for printing -- but this is speculation on my part. Perhaps Alex can comment on this.


Kind regards,
Thom



On Tue Aug 30 '16 6:19pm, GrEv wrote
------------------------------------
>Dear Thom,

>Thanks for your reply. In my case there are only population analysis printed out at the end of geometry optimization. Actually, I though that the problem/inconvenience can relate to that I do a SA-MCSCF geometry optimization (state-averaging over 2 states) rather than a state-specific one. Can this be the reason?

>Best regards,
>Evgeniy

>On Mon Aug 29 '16 9:36pm, Thomas Pijper wrote
>---------------------------------------------
>>Dear Evgeniy,

>>If I recall correctly MCSCF orbitals are always printed at the end of a successful geometry search, provided you set NPRT=0 in $STATPT. Note that '0' is the default value of this option, so not specifying any value for NPRT should already cause MCSCF orbitals to be printed.
>>
>>
>>Kind regards,
>>Thom
>>
>>
>>
>>On Mon Aug 29 '16 5:06pm, GrEv wrote
>>------------------------------------
>>>Hello,

>>>I would like to print out MCSCF orbitals at the end of MCSCF geometry optimization run. Any point how to do that will be greatly appreciated.

>>>Best regards,
>>>Evgeniy