Siddheshwar Chopra
sidhusai@gmail.com
Please help me.
On Sun Mar 16 '14 6:01am, Pavlo Solntsev wrote
----------------------------------------------
>Dear Siddheshwar.
>Please, use the search tool-chain for this site. All you problems were discussed in this forum.
>1) Read the manual, specifically command line section (how to run FF)
>2) Manual also has example of script how to run FF exactly with IntelMPI. do search.
>3) If you can't find answer by using search and/or manual, put EXACT command line or script you use to tun FF.
>If you need a help with scripting i may help.
>Pavlo.
>
>
>
>
>On Sat Mar 15 '14 9:32am, Siddheshwar Chopra wrote
>--------------------------------------------------
>>Dear Sir,
>>I could manage to remove the "Unable to open input file" error by giving the absolute path to the i/p file.. But now I am struggling with the following persistent error::
>>p4_error: semget failed for setnum: 0
>>Over the internet I came across "cleanipcs". Please help me..I am unable to progress with my work. This error is repeating everytime; not allowing the program to run.
>>Regards,
>>On Sat Mar 15 '14 7:27am, Siddheshwar Chopra wrote
>>--------------------------------------------------
>>>Dear Sir,
>>>Yes I have read the manual.. Could you please point out the mistake Sir. Perhaps it is a very silly mistake. I am new to Linux and need to stay with it for a while. Please help.
>>>Regards,
>>>On Fri Mar 14 '14 10:06pm, Pavlo Solntsev wrote
>>>-----------------------------------------------
>>>>Dear Siddheshwar.
>>>>Did you consult the manual for Firefly's command line options?
>>>>Pavel.
>>>>
>>>>
>>>>
>>>>On Fri Mar 14 '14 3:06pm, Siddheshwar Chopra wrote
>>>>--------------------------------------------------
>>>>>Dear Sir,
>>>>>I am running Firefly801 executable file from unzipped ff801 (relatively located) folder. The system has Intel MPI installed on it. I am running an i/p file xyz.inp located inside ff801/INPUT directory using ::
>>>>>mpirun -np 2 ./firefly801 -r -f -p -i /path/INPUT/xyz.inp
>>>>>But I am getting this error:::
>>>>>FATAL ERROR INITIALIZING FIREFLY! CHECK YOUR COMMAND LINE OPTIONS!
>>>>> ON MASTER NODE, ERROR CODE IS : 0x00000001
>>>>> Unable to open input file
>>>>>Also please tell how to use -stdext -ex?? What is it used for??
>>>>>Regards,