Firefly and PC GAMESS-related discussion club

 
Learn how to ask questions correctly  
 
 

 

Pavlo Solntsev
pavlo.solntsev@gmail.com

Please, use the search tool-chain for this site. All you problems were discussed in this forum.
1) Read the manual, specifically command line section (how to run FF)
2) Manual also has example of script how to run FF exactly with IntelMPI. do search.
3) If you can't find answer by using search and/or manual, put EXACT command line or script you use to tun FF.

If you need a help with scripting i may help.

Pavlo.




On Sat Mar 15 '14 9:32am, Siddheshwar Chopra wrote
--------------------------------------------------
>Dear Sir,
>I could manage to remove the  "Unable to open input file" error by giving the absolute path to the i/p file.. But now I am struggling with the following persistent error::

>p4_error: semget failed for setnum: 0

>Over the internet I came across "cleanipcs". Please help me..I am unable to progress with my work. This error is repeating everytime; not allowing the program to run.

>Regards,

>On Sat Mar 15 '14 7:27am, Siddheshwar Chopra wrote
>--------------------------------------------------
>>Dear Sir,
>>Yes I have read the manual.. Could you please point out the mistake Sir. Perhaps it is a very silly mistake. I am new to Linux and need to stay with it for a while. Please help.

>>Regards,

>>On Fri Mar 14 '14 10:06pm, Pavlo Solntsev wrote
>>-----------------------------------------------
>>>Dear Siddheshwar.

>>>Did you consult the manual for Firefly's command line options?

>>>Pavel.
>>>
>>>
>>>
>>>On Fri Mar 14 '14 3:06pm, Siddheshwar Chopra wrote
>>>--------------------------------------------------
>>>>Dear Sir,
>>>>I am running Firefly801 executable file from unzipped ff801 (relatively located) folder. The system has Intel MPI installed on it. I am running an i/p file xyz.inp located inside ff801/INPUT directory using ::

>>>>mpirun -np 2 ./firefly801 -r -f -p -i /path/INPUT/xyz.inp
>>>>But I am getting this error:::

>>>>FATAL ERROR INITIALIZING FIREFLY! CHECK YOUR COMMAND LINE OPTIONS!

>>>> ON MASTER NODE, ERROR CODE IS : 0x00000001
>>>>    Unable to open input file

>>>>Also please tell how to use -stdext -ex?? What is it used for??

>>>>Regards,

[ This message was edited on Sun Mar 16 '14 at 6:01am by the author ]