Thomas Pijper
thomaspijper@hotmail.com
If I recall correctly MCSCF orbitals are always printed at the end of a successful geometry search, provided you set NPRT=0 in $STATPT. Note that '0' is the default value of this option, so not specifying any value for NPRT should already cause MCSCF orbitals to be printed.
Kind regards,
Thom
On Mon Aug 29 '16 5:06pm, GrEv wrote
------------------------------------
>Hello,
>I would like to print out MCSCF orbitals at the end of MCSCF geometry optimization run. Any point how to do that will be greatly appreciated.
>Best regards,
>Evgeniy