Firefly and PC GAMESS-related discussion club

 
Learn how to ask questions correctly  
 
 

 

Pavlo Solntsev
pavlo.solntsev@gmail.com

Good luck.

Pavlo.


On Mon Jul 28 '14 2:46pm, Siddheshwar Chopra wrote
--------------------------------------------------
>Dear Pavlo,
>As discussed with you, I used Gabedit for obtaining the uv spectra. It shows the spectra very well. But when I save its ASCII file, I am unable to open it in the QTIPLOT (due to a single space). I need the data in two column form which could directly be imported into Qtiplot. Any suggestions?

>Regards,

>On Sat Jul 26 '14 1:04am, Pavlo Solntsev wrote
>----------------------------------------------
>>no

>>On Fri Jul 25 '14 10:14pm, Siddheshwar Chopra wrote
>>---------------------------------------------------
>>>Dear Pavlo,
>>>Yes oscillator strengths have been calculated... I used Gausssum 2.2.5. I have Gabedit too. I will try and let u know soon. Just a little doubt:: does it have to do anything with SBKJC?

>>>Regards,

>>>On Fri Jul 25 '14 5:12pm, Pavlo Solntsev wrote
>>>----------------------------------------------
>>>>If osc.strengths are ok, then your calculation is ok. How you make epsilon is a different question and should be addressed to a program you use. I personally use Gabedit to get "UV-vis" spectra.

>>>>Hope this helps.

>>>>Pavlo.
>>>>
>>>>
>>>>
>>>>
>>>>On Fri Jul 25 '14 9:12am, Siddheshwar Chopra wrote
>>>>--------------------------------------------------
>>>>>Dear All,
>>>>>I recently ran a TDDFT calculation using SBKJC ECPs for obtaining uv absorption spectra. Please find attached the image of spectra obtained. I can see the oscillator strength values, but the absorbance values are seeming weird to me. Please could anyone throw some light on this?

>>>>> $SYSTEM MEMORY=94459319 aoints=dist TIMLIM=5295600 KDIAG=-1 $END
>>>>> $CONTRL INTTYP=HONDO ICUT=11 ITOL=30 SCFTYP=RHF $END
>>>>> $CONTRL DFTTYP=B3LYP COORD=UNIQUE NZVAR=200 CITYP=TDDFT $END
>>>>> $CONTRL MAXIT=10000 MOLPLT=.t. PLTORB=.t. GENCON=.t. ECP=SBKJC $END
>>>>> $BASIS GBASIS=SBKJC $END
>>>>> $STATPT opttol=10E-7 NSTEP=200 Method=GDIIS $END
>>>>> $DFT LMAX=65 NRAD=99 $end
>>>>> $ZMAT DLC=.t. AUTO=.t. $END
>>>>> $SCF NCONV=7 $END
>>>>> $TDDFT NSTATE=100 ISTSYM=0 ISTATE=1 TDA=.t. $END

>>>>>For the plot, FWHM=3000 and no. of points were 500.

>>>>>Regards,

>>>>>